Instructions: on how to apply your UV DTF PermaStickers, Step-By-Step!

​To get started, there are 4 easy step on how to apply your custom UV DTF PermaStickers!

​

STEP 1

1- Prep Your Surface and Pre-Squeegee Your UV DTF PermaSticker

Prepping the Area- When necessary, clean the surface of your item before applying the PermaSticker using either soap & water, all purpose cleaner, or a mixture of rubbing alcohol and water (50/50 mix).

​

Pre-Squeegee - Before applying , place your design face down with the white ink side facing up, Using the padded end of the squeegee, run over the whole design with firm pressure, back and forth 2 - 4 times to push the PermaStickers onto the top carrier sheet. You'll learn when this is necessary with experience.

​

STEP 2

​2 - Preparing your UV DTF PermaSticker for Transfer

Gently peel the two sheets apart, watching to ensure the whole design lifts off onto the top carrier sheet. Design which contain thin lines and small separated elements, such as small text, the slower you should peel. if parts don't lift, re-squeegee from behind, and attempt to peel again from a different angle. You'll get a feel for it with experience.

STEP 3

​3 - Placing your UV DTF PermaSticker onto Your Item

First, identify the placement area on your item. For smaller designs: (5 inches & under), carefully place the design onto the placement area with two hands controlling the placement. For larger designs: (6 inches & larger), you may find it easier to place the sticker starting from one side and ending at the other. This will help control your placement, reduce bubbles underneath the design, and avoid wrinkling of the top carrier sheet which could cause design elements to be offset and/or design overlapping.

​

Tip: Leave a corner of the top carrier sheet unpressed to the product for easy peeling.

​​

STEP 4

​4 - Completing the Transfer process

After placing the design, firmly press with your fingers or squeegee it 2 - 4 times. You'll get a feel for how much TLC it requires with experience. Peel slowly, watching to ensure all elements stick. Use your EYES and not just your hands. If any part of the design is not adhering, lay the top carrier sheet back down, re-squeegee and try peeling from a different angle.

​

​

PRO SHIRT FACTORY HOPE'S YOU HAVE FUN WITH YOUR UV DTF PermaSticker DESIGN!

​

​